Visible Image Stamps and Stencils, Distress Inks, Versafine, Wow Embossing Powders, and Ranger Rock Candy Crackle Paint.

Hello there,

I'm back with one of my 'Visible Image' creations, as it's 

Fabulous Fortnightly Friday.

I thought I'd make something suitable for the Halloween mood, that a lot of Crafters seem to be in at the moment....... well, it is only a couple of weeks away !!!!

The fabulous 'Visible Image' stamps I used were........ 

How Fragile, Glimmer of Light, Mr Bone Jangles, and Shining Bright.

the stencil I used was...... Dark Hearts.

So, first thing was to blend a background, using Mustard Seed, Picked Raspberry and Salty Ocean Distress Inks (my three 'go too' colours), then with some water in my hand I splashed it, dripping it around, then drying it with my heat tool. I then stamped twice in the middle of the background, with the cracked glass stamp out of the 'How Fragile' set, using Worn Lipstick Oxide Ink.

 Placing the stencil onto the background, I blended through it  with Chipped Sapphire Distress Ink, but only around the edges, I took the stencil away, then again all the edges again with the same ink.

On some new white card, with the light bulb stamps, (masking off the filament), I stamped using Versafine Onyx Black, I then stamped the large skull, into the large light bulb, using Versafine Clair ink in colour 'Cheerful', and using a Koi orange watercolour pen, I  coloured the middle bit, I repeated this with the smaller skull into the smaller light bulb.
Using the little light bulb from the 'Glimmer of Light' set, again masking off the filament, I stamped 5 of them, then, just using the head of the skeleton, I stamped it inside the bulbs. I also stamped the sentiment, and fussy cut everything.

On some black card, I stamped the whole skeleton with embossing ink, then used 'Wow Opaque Bright White Embossing powder, heated it, then fussy cut that too. 

I also stamped the wonderful Death Head Moth onto some white card, heat embossed it with 'Wow' Primary Ebony Embossing Powder, fussy cut it, then coloured with Koi watercolour pens.

I attached everything together, using Pinlair 3D Glue Gel, then painted a thick coat of Ranger Rock Candy Crackle Paint, onto all the bulbs.

Here are all the Visible Image places, for you to check out......

The SHOP, where you can find all the Visible Image Stamp collections.

The BLOG, catch up with all the Visible Image news.

The FACEBOOK GROUP, where you can enter the 'Show and Tell'.

The FACEBOOK PAGE, where there are exiting weekly giveaways.

and the three social media sites......

PINTEREST, TWITTER and INSTAGRAM.

Hugs, Pauline xxxxx